ANSI/AWWA C214-07

This standard covers the materials and application of tape coating systems in coating plants at fixed sites, using coating techniques and equipment as recommended by the tape coating manufacturer. For normal construction considerations, prefabricated, polyolefin tapes are applied as a three-layer system consisting of: liquid adhesive; corrosion-preventive tape (inner layer); and mechanical-protective tape (outer layer).

This standard establishes the minimum requirements for tape coating systems used on the exterior of steel water pipelines in the potable-water supply industry. Continuous monitoring of all application procedures for the tape coating systems shall be done by the constructor. All AWWA pipe coating standards are intended for potable-water service. Therefore, the maximum service temperature of this coating is based on the maximum service temperature of potable water. These coating systems will perform at higher temperatures.

This standard does not cover the additional materials and procedures that may be required for difficult conditions, such as those encountered in rocky areas and in construction of underwater lines, casing pipe, and river crossings outside the scope of AWWA C214.

The purpose of this standard is to provide purchasers, manufacturers, and constructors with the minimum performance requirements for tape coating systems for the exterior of steel water pipelines, including system components, application, inspection, testing, and marking and packaging requirements.

This product replaces:ANSI/AWWA C214-00 - Tape Coating Systems for the Exterior of Steel Water Pipelines

Browse Product Family:

ANSI/AWWA C214-07
ANSI/AWWA C214-00
ANSI/AWWA C214-95

People Who Bought This Also Bought:
AWWA C210-07- Liquid-Epoxy Coating Systems for the Interior and Exterior of Steel Water PipelinesANSI/AWWA C209-06- Cold-Applied Tape Coatings for the Exterior of Special Sections, Connections, and Fittings for Steel Water PipelinesANSI/AWWA C200-05- Steel Water Pipe - 6 in. (150 mm) and LargerANSI/AWWA C207-07- Steel Pipe Flanges for Waterworks Service, Sizes 4 In. Through 144 In. (100 mm Through 3,600 mm)ANSI/AWWA C206-03- Field Welding of Steel Water PipeANSI/AWWA C213-07- Fusion-Bonded Epoxy Coating for the Interior and Exterior of Steel Water PipelinesAWWA M11- Steel Water Pipe: A Guide for Design and Installation (M11), Fourth EditionANSI/AWWA C203-08- Coal-Tar Protective Coatings and Linings for Steel Water Pipelines - Enamel and Tape - Hot-AppliedAWWA C205-07- Cement-Mortar Protective Lining and Coating for Steel Water Pipe, 4 In. (100 mm) and Larger, Shop AppliedANSI/AWWA C208-07- Dimensions for Fabricated Steel Water Pipe Fittings